Project Tall Order
 

This will be my 4th case, and without a doubt, its a tall order. Both in time, money and effort.

http://www.arach.net.au/~credo/image...t_sketch_1.jpg
Click for full image
Still no solid plans yet, just few rough ideas and a few unfinished sketches like this front intake/blowhole.


As you can see its a huge old heavy mother of a case.. I love it, this is going to be so much fun. both side panels are missing and so is the door off the front, I shouldnt be needing them anyway, gives me a chance to make up something else instead.

http://www.arach.net.au/~credo/image...case%20007.jpg
Click for full image

http://www.arach.net.au/~credo/image...case%20010.jpg
Click for full image
the back needs a lot of work. I will probably be fitting two PSU's.. or watercooling, or both. This case is tall enough to do it all.

http://www.arach.net.au/~credo/image...case%20014.jpg
Click for full image
These bloody serial port mounts will have to go

http://www.arach.net.au/~credo/image...case%20015.jpg
Click for full image
Eek! No drive bays.. I'm just going to have to make some up.

http://www.arach.net.au/~credo/image...case%20017.jpg
Click for full image
Just another before shot.

http://www.arach.net.au/~credo/image...case%20018.jpg
Click for full image
The plastic bezel. kinda sucks. Might go over well with a bit of work.

Well there we have it. this one is going to be a long haul. so updates will be a bit spaced out.

lol damn....you have your work cut out for you on that one.